Locksmith

I got a smart lock and it says I need a minimum door thickness of 40mm.
My door is 35mm…
5mm doesn’t seem much but is it going to be a problem?

Asked by Gc about 2 years ago

Yes it will be a problem. You can just install some plates to make up the difference. They make adapter plates for this very purpose, unless it’s a unique footprint, you may have to custom make some plates.

I want to convert a push bar door to electronic mag-lock (prox tags, fingerprint, phone....etc).

Do I need to get a special type for a push bar or can I use any type with a magnetic strike plate?

Asked by JoelN about 2 years ago

There are a lot of components that goes into the set up you are talking about. It’s very difficult to interpret what you’re trying to do exactly, I’m not sure you’re using the correct terminology. This set up consist of a special type of push bar that has a switch in it, a mag lock, power supply, some form of card reader, fingerprint reader etc. I would highly recommend hiring a professional as this is something that needs to be designed & installed correctly. There are also local codes that restrict usage of mag locks in some areas, or require special permits for installation of these.

Needing help on the master pins for three keys, grand master, master and tenat

Asked by Automat3d 4 months ago

can i copy my 1974 ford bronco key(non fob) onto any other non fob blank car key? i have a specific blank car key (Subaru) that i want it copied to?

Asked by bronco guy 3 months ago

Door lock bolt jammed into door frame

Asked by Sam 8 months ago

I replaced the ignition switch in 2006 dodge ram 1500 bc I lost my only key to vehicle...the new key will not start the truck ...can locksmith help with this?

Asked by Felicia Bishop 8 months ago

I’m a rookie locksmith trying to fit a key for a 2006 Honda cbr 600 . Any advice would be greatly appreciated

Asked by Tgonza24@gmail.com 7 months ago